Fixed a unit conversion error in some LT-600 series cable testers.

Problem Description:

Some devices are experiencing unit conversion errors. When testing network cables using the RJ45TDR Test application, the measurement results are accurate when the length unit is set to "Meters". However, when the unit is switched from "Meters" to "Feet" or "Inch", obvious errors occur.

Solution: 

This issue primarily affects some devices with serial numbers starting with 66860. If your device falls within this range and is experiencing the same problem, you can update the tester to the latest version via online update. This will resolve the issue. If your device does not exhibit this problem, we do not recommend updating it.

Online Update Instructions:

Please connect the tester to the Internet, then go to "Settings" -- "System Update" -- "Online Update". The new version V01.00 041 will pop up automatically. Please update your device online. 

NOTE: If the online update file is not displayed within 20 seconds after clicking the "Online Update" button, please check if the tester's IP address is set correctly or set the IP address mode to DHCP mode instead of static IP.

If you have any other questions, please feel free to contact our technical support team: Service@rsrteng.com.

Thank you.